Filter
Top Products
Press the AUD button to end the control mode.
Setting the high-pass filter
You can separately set the high-pass filter for front and rear
output, including preouts. The high-pass filter works except
during non- fading preout when switching to non-fading.
The factory default settings for front output and rear output are
"through".
NOTE
4
Adjustment mode
(Display;
KRC-PS1077R, 977R/
KRC-877R, 877W, 777R)
Bass
("Bass/Bas")
Treble
("Treble/Tre")
Balance
("Balance/Bal")
Fader
("Fader/Fad")
Non-Fading
Preout Level
("NF pre Level/
NFLevel")
Bass decreased.
Treble decreased.
Bass increased.
Treble increased.
4 button ¢ button
Operation of Audio control button
Low-pass filter
for Non-fading
output
("LPF NF pre/
LPF NF")
High-pass filter
for front output
("HPF Front/
HPF F")
High-pass filter
for rear output
("HPF Rear/
HPF R")
Phase for Non-
fading output
("NF pre Phase/
NF Phase")
You can select the frequency to be cut, as
follows:
50Hz ↔ 80Hz ↔ 120Hz ↔
Through/Throu (through)
You can select the phase for non-fading output,
as follows:
Normal (0°) ↔ Reverse (180°)
Front and rear
channels (including
preout) emphasized.
You can select the frequency to be cut, as
follows:
Through/Throu (through) ↔ 40Hz ↔ 60Hz ↔ 80Hz
↔ 100Hz ↔ 120Hz ↔ 150Hz ↔ 180Hz ↔
You can select the frequency to be cut, as
follows:
Through/Throu (through) ↔ 40Hz ↔ 60Hz ↔ 80Hz
↔ 100Hz ↔ 120Hz ↔ 150Hz ↔ 180Hz ↔
Non-fading sound
emphasized.
Front channel increased.
Rear channel increased.
Right channel emphasized.
Left channel
emphasized.
Adjust various parameters of sound quality.
Press the AUD button to enter the control mode.
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the FM button advances the display, and pressing the
AM button reverses it.
Source tone memory
Each source (tape, FM, AM, and disc changer) has its own
memory in which to store the bass, treble and N-F level settings.
The settings made for a particular source are then recalled
automatically whenever you use that source (e.g., FM mode uses
the tone settings made for FM, AM for AM, etc.).
Press the 4/¢ button.
Look at the table to adjust the mode being displayed.
3
NOTE
Bass
Rear High-pass filter*
1
N-F Low-pass filter*
1,2
Treble
Front High-pass filter*
1
Balance
N-F Level*
1,2
N-F Phase*
1,2
Fader
KRC-777R:
*
1
None
KRC-PS1077R/977R/877R/877W:
*
2
Not available during the Dual zone system on.
/
Only when Non-fading is switched on.
2
1
Audio Control Setting
Other features
— 30 —
English