Filter
Top Products
— 26 —
English
Disc control features (See page 7)
Presetting Disc Names
Store the names of discs to be displayed when played.
Play the disc whose name you want to preset.
• This function is not available for disc changers that do not feature
the Disc Name Preset function.
• This procedure is not to be used to store the disc and track
titles for MDs that you record.
Hold down the NAME.S button for two seconds or more.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the
TRACK
+ or TRACK– buttons, respectively, on the remote
control.
Each press of the 38 button results in the type of characters
that are to be entered changing between alphabet and
numeral/symbols.
Press the DISC
+ or DISC– button to display the desired
character.
Characters that can be displayed are as follows.
Alphabet (upper case) : A ~ Z
Numerals and symbols : 1~9 0 @ ” ‘ ` % & * + - = , . / \ < > [ ]
The operation and characters that can be entered may change as
listed below, depending on the unit that is connected.
A press of the 38 button exits the disc name preset mode.
Operations can be followed again from Step 2 at a time such as
this, and the characters to be input are selected using the
procedure described below.
Press the DISC+ or DISC– button to display the desired
character.
Besides the alphabet (capital letters only) and numerals, you can
choose the following characters: /, +, –, *, =, <, >, [ and ]
NOTE
4
3
2
NOTE
1
Direct Alphabet Input
If the disc changers that were manufactured and sold after 1997
are connected, you can directly input letters using the
number/letter entry buttons on the remote control.
Example: Use the following table to enter the name "DANCE".
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to 8 characters for each name.
Press either the NAME.S button on the main unit or the OK
button on the remote control.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters entered so far.
• The number of discs whose names can be stored will differ
depending on the disc changer that is connected. Please see
your disc changer manual for details.
• Discs are identified by their total length and number of tracks. If
you play another CD that happens to have exactly the same
specifications as another CD whose name is stored, the wrong
name will be displayed for it.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to enter the
changes.
• Pressing the reset button does not erase the disc names stored
in a disc changer.
NOTE
6
NOTE
5
NOTE
Button to press # Times pressed
Character
#3 1“D”
1“A” #2
#6“N” 2
#2 3“C”
#3“E” 2