Filter
Top Products
Other features (See page 7)
— 21 —
Audio Control Setting
Adjust various parameters of sound quality.
Press the AUD button to enter the control mode.
Each time the AUD button is pressed, the adjustment mode
display changes as follows:
If you do not move to step 2 in 5 seconds, the unit will switch
back to the volume adjustment mode (i.e., the normal mode).
Source tone memory
Each source (tape, FM, AM, and disc changer) has its own mem-
ory in which to store the bass and treble tone settings.
The settings made for a particular source are then recalled auto-
matically whenever you use that source (e.g., FM mode uses the
tone settings made for FM, AM for AM, etc.).
Press the d/u buttons to adjust the mode shown in the dis-
play.
Use the following table as a guide for adjusting the settings in
each mode.
2
NOTE
1
7 Bass 7 Treble 7 Balance 7 Fader 7 Volume
Bass
(“BAS”)
Treble
(“TRE”)
Balance
(“BAL”)
Fader
(“FAD”)
Bass decreased.
Treble decreased.
Left channel empha-
sized.
Rear channel
increased.
Bass increased.
Treble increased.
Front channel
increased.
Right channel empha-
sized.
Adjustment
mode
(Display)
d button u button
Operation of Audio control button
Clock Display
Display the time.
Switching to Time Display:
Press the CLK button repeatedly until the clock is displayed.
Adjusting Time
When the RDS station tuned into is transmitting a time signal,
have the unit’s built-in time adjust automatically to the cor-
rect local time.
Adjusting the Time:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
• The displayed time cannot be set manually, but only through
RDS station time signals.
• The time is not adjusted when the RDS station you are tuned to
is not transmitting a time signal. Choose another RDS station in
such a case.
NOTE
TEL Mute Function
1
Shut down the audio system temporarily whenever an incom-
ing call is received.
The function will not work if a cable is not connected to the car
phone.
When the telephone rings:
When a call is received, "CALL" is displayed and all the unit
functions are temporarily interrupted.
Restoring Original Unit Source During Phone Call:
Press the SRC button.
"CALL" disappears from the display, and the volume of the orig-
inal source is restored gradually.
Turning TEL Mute Function Off After Phone Call:
Hang the phone up.
"CALL" disappears from the display.
The original source (i.e., the one used before the phone call) is
returned to automatically, and the volume restored gradually.
NOTE
Function of the KRC-259R,159RA/RG,21R