Kenwood KMF-X9000 Stereo Amplifier User Manual


 
8
EN
Power amplifier section
Rated power output
For other countries
STEREO MODE
130 watts per channel minimum RMS, both channels
driven at 6 , from 20 Hz to 20,000 Hz with no more
than 0.02 % total harmonic distortion (FTC)
MONO (BTL) MODE
270 watts minimum RMS, at 6 , from 20 Hz to 20,000
Hz with no more than 0.03 % total harmonic distor-
tion (FTC)
Frequency response
MAIN IN .......................... 5 Hz ~ 100 kHz, +0 dB, 3 dB
Signal to noise ratio
(IHF'66)
MAIN IN ....................................................... 115 dB
Input sensitivity / Impedance
STEREO MODE
MAIN IN .............................................. 1.1 V / 20 k
MONO (BTL) MODE
MAIN IN ............................................. 1.5 V/ 100 k
For Europe
(IEC)
STEREO MODE
From 20 Hz to 20,000 Hz, 0.7 % T.H.D. at 6
........................................................ 130 W+ 130 W
MONO (BTL) MODE
From 20 Hz to 20,000 Hz, 0.7 % T.H.D. at 6
...................................................................... 270 W
(DIN)
STEREO MODE
1 kHz, 0.7 % T.H.D. at 6 Ω ............... 145 W + 145 W
MONO (BTL) MODE
1 kHz, 0.7 % T.H.D. at 6 Ω ................................285 W
Total harmonic distortion
STEREO MODE
..................... 0.02 % (20 Hz ~ 20 kHz, 130 W, 6 )
................................. 0.0018 % (1 kHz, 130 W, 6 )
........................................ 0.05 %(1 kHz, 50 W, 2 )
MONO (BTL) MODE
..................... 0.03 % (20 Hz ~ 20 kHz, 270 W, 6 )
................................. 0.0018 % (1 kHz, 270 W, 6 )
Specifications
For your records
Record the serial number, found on the back of the unit, in
the spaces designated on the warranty card, and in the space
provided below. Refer to the model and serial numbers when-
ever you call upon your dealer for information or service on
this product.
Model
Serial Number
General
Power consumption ..................................................... 3.5 A
...................................................................... 320 W
......................................... Less than 2 W (Standby)
Dimensions
W: ................................................... 440 mm (17-5/16")
H: ..................................................... 128 mm (5-1/32")
D: ................................................... 385 mm (15-5/32")
Weight (net ) ............................................... 12.3 kg (27.2 Ib)
KENWOOD follows a policy of continuous advancements in
development. For this reason specifications may be changed
without notice.
Manufactured under license from Lucasfilm Ltd. Lucasfilm
and THX are trademarks or registered trademarks of
Lucasfilm Ltd.
For U.S.A.
FCC WARNING
This equipment may generate or use radio frequency en-
ergy. Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly
approved in the instruction manual. The user could lose the
authority to operate this equipment if an unauthorized
change of modification is made.
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference in a resi-
dential installation. This equipment may cause harmful
interference to radio communications, if it is not installed
and used in accordance with the instructions. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and re-
ceiver.
Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.