Kenwood VR-906 Stereo System User Manual


 
6
EN
ON OFF
POWER
PHONES
SPEAKERS ON/OFF
ON/STANDBY
STANDBY
ACTIVE EQ
ACTIVE EQ DTS
DOLBY DIGITAL
INPUT MODE BAND AUTO/MONO MEMORY SETUP
MUTE
DOWN UP
MULTI CONTROL INPUT SELECTOR
VOLUME CONTROL
SOUND
DIMMER LISTEN MODE
ON/STANDBY
STANDBY
POWER
Names and functions of parts
Main Unit
Standby mode
While the standby indicator is lit, a small amount of power is supplied to
the system to back-up the memory. This is called standby mode. Under
the condition, the system can be turned ON by the remote control unit.
Display
Band indicators
NEO:6
indicator
Frequency display,
Input display,
Preset channel display,
Surround mode display
Speaker indicator
PRO LOGIC
indicator
AUTO DETECT indicator
DOLBY DIGITAL
indicator
DTS indicator
CLIP indicator
MUTE indicator
TONE indicator
LOUDNESS indicator
TUNED indicator
DSP MODE
indicator
DIGITAL indicator
ST. indicator
AUTO indicator
DISCRETE 6.1
indicator
MATRIX 6.1
indicator
CAUTION
The power in this equipment will not be completely cut off from the AC
wall outlet when the main switch is turned OFF.
For VR-906/
VR-905
1 POWER ON/OFF key ^
(For KRF-V6090D/KRF-V5090D)
Use to turn the main power ON/OFF.
2 ON/STANDBY
key ^
(For KRF-V6090D/KRF-V5090D)
Use to switch the power ON/STANDBY when
the POWER is turned ON.
STANDBY indicator
2 POWER ON/STANDBY
key
(For VR-906/VR-905) ^
Use to turn the power ON/STANDBY.
STANDBY indicator
3 DIMMER key
Use to select the REC MODE. )
Use to adjust the brightness of the display.
4 LISTEN MODE key
Use to select the listening mode.
5 Surround LED (light-emitting diode)
indicators
ACTIVE EQ mode LED indicator )
Lights when this model is in the ACTIVE EQ
mode.
DTS mode LED indicator
Lights when this model is in the DTS mode.
DOLBY DIGITAL mode LED indicator
Lights when this model is in the Dolby Digital
mode.
6 SOUND key
Use to adjust the sound quality and the
ambience effects.
7 MULTI CONTROL knob ^
Use to control a variety of settings.
8 INPUT SELECTOR knob *
Use to select the input sources.
9 VOLUME CONTROL knob (
0 PHONES jack )
Use for headphone listening.
! SPEAKERS ON/OFF key *
Use to turn the speakers ON/OFF.
@ ACTIVE EQ key )
Use to select ACTIVE EQ setting.
# INPUT MODE key 8
Use to switch between full auto, digital and
analog inputs.
$ BAND key ¡
Use to select the broadcast band.
% AUTO/MONO key
Use to change “TAPE” indication to “MD”.
*
Use to select the auto tuning mode. ¡
^ MEMORY key
Use to store radio stations in the preset
memory.
& SETUP key ^
Use to select the speakers' settings etc.
* MUTE key )
Use to temporarily mute the sound.
6CH INPUT indicator
(KRF-V6090D/KRF-
V5090D only)
Input channel indicators
*The Input channel indicators light
up to indicate the channels con-
tained in the input signal. The "S"
indicator lights when the surround
component consists of a single
channel.
04.11.25, 18:546