Kenwood CT-2050 Stereo System User Manual


 
23
CT-2050/203/KXF-W6010/W4010 (En/M)
÷Set the timer so that the tape starts at the desired time of the day.
÷When the set time comes, tape playback starts automatically.
÷Read carefully the instruction manual of your audio timer.
5
Set the timer.
4
Set the TIMER switch to PLAY.
Timer playback of tape
3
Rewind the tape(s) to the start position.
2
Adjust the volume of the amplifier.
1
Start playback.
Preparation
This unit incorporates a built-in timer standby function. By
using an audio timer optionally available in the market,
wake-up playback and unattended recording of tape can be
started at any time of the day. Connect the power cords of
the components directry or indirectly to the timer so that
their powers can be turned on via the timer.
The timer setup operation varies depending on the timer.
Also read carefully the instruction manual of your audio
timer.
Timer operations
Audio timer
To AC outlet
Tuner
(CT-2050/203/KXF-W6010/W4010)
Amplifier
1. When connecting the KENWOOD equipment (amplifier, CD player) and the system, remove the disc from the CD player.
2. If relay playback is required, set to
[[
[[
[ or
.
3. If tapes are inserted in both decks A and B, timer playback starts with deck B.
4. Switch on the power to the cassette deck. (The timer will not operate if it is switched off.)
1
Set the power switches of the compo-
nents to ON.
2
Set the input selector of the amplifier to
TAPE.
3
Make "Playback (recording) preparation".
0
(If relay playback is required, insert tapes
in both decks A and B.)
REVERSE
2
FORWARD
3
STOP
7
¡1
TIMER
REC OFF PLAY
Notes
Notes