Filter
Top Products
English
|
13
Adjustment Item Display Range
Front High Pass Filter*
2
"HPF-F Fc" Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter*
2
"HPF-R Fc" Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter*
1,2
"LPF-SW" 50/60/80/100/120/
Through Hz
Subwoofer Phase*
1,2
"SW Phase" Reverse (180°)/ Normal (0°)
Volume offset "Vol-Offset" –8 — 0
Loudness "LOUD" OFF/ON
Dual Zone System "2 ZONE" OFF/ON
• Volume offset: Each source’s volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
• *
1
You can control this item when <Switching preout>
(page 36) is set to "SWPRE Sub-W". (KDC-W7031 only)
• *
1
You can control this item when <Subwoofer
Output> (page 13) is set to "SW ON".
• *
2
You can control this item when "2 ZONE" of <Audio
Setup> is set to "OFF".
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- The channel of sub source is set up by <Dual Zone
System Setting> (page 38).
- Main source is selected by [SRC] button.
- The volume of Front channel is adjusted by [VOL]
knob.
- The volume of Rear channel is adjusted by <Audio
Control> (page 12).
- The Audio Control has no effect on sub source.
• The Dual Zone System can be used with the Auxiliary
input sources shown below.
- Internal auxiliary input (KDC-W8531/W7531 only)
- Option CA-C1AX (KDC-W7031 only)
5 Exit Audio Setup mode
Press [VOL] knob for at least 1 second.
Equalizer Control
1 Select the source for adjustment
Press the [SRC] button.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "SYS.Q" is
displayed above the [1] button.
Refer to <Notes on Multi-function Key System>
(page 9).
3 Enter Equalizer Control mode
Press the [1] ("SYS.Q") button.
4 Select the Equalizer Control item for
adjustment
Press the [1] ("SYS.Q") button.
5 Adjust the Equalizer control item
Push the Control knob to [4] or [¢].
Each time the knob is pushed, the setting
switches as shown below.
Sound setting Display
User memory "USER"
Rock "ROCK"
Pops "POPS"
Easy "EASY"
Top 40 "TOP 40"
Jazz "JAZZ"
Natural "NATURAL"
• User memory:
The values set on the <Audio Control> (page 12).
• Each setting value is changed with the <Speaker
Setting> (page 11).
First, select the speaker type with the Speaker setting.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Hold down on [AM] of the Control knob for at
least 1 second.
Each time the button is pressed, Subwoofer
output switches ON and OFF.
When it’s ON, "SW ON" is displayed.
• You can control this item when <Switching preout>
(page 36) is set to "SWPRE Sub-W". (KDC-W7031 only)
• You can control this item when "2 ZONE" of <Audio
Setup> (page 12) is set to "OFF".