Filter
Top Products
6
|
KDC-W3041/KDC-W312/KDC-W241/KDC-241
General Operation
Audio Control
1
Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Audio item to adjust
Press the [VOL] knob.
Adjustment Item Display Range
Subwoofer level* “SW L” –15 — +15
System Q “NATURAL”/
“ROCK”/“POPS”/
“EASY”/“TOP40”/
“JAZZ”/“USER”
Natural/Rock/Pops/Easy/Top
40/Jazz/User setting
Bass level “BAS L” –8 — +8
Middle level “MID L” –8 — +8
Treble level “TRE L” –8 — +8
Balance “BAL” Left 15 — Right 15
Fader “FAD” Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
*Function of KDC-W3041/W312.
⁄
• “USER”: This appears when Bass level, Middle level, and
Treble level are adjusted. When “USER” is selected,
these levels are recalled.
4 Adjust the Audio item
Turn the [VOL] knob.
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob.
Audio Setup
Setting the Sound system.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Adjustment Item Display Range
Low Pass Filter* “LPF” 80/120/160/Through Hz
Volume offset “V-OFF” –8 — ±0 (AUX: -8 — +8)
*Function of KDC-W3041/W312.
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
4 Adjust the Audio setup item
Turn the [VOL] knob.
5 Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
Speaker type Display
OFF “SP OFF”
For 5 & 4 in. speaker “SP 5/4”
For 6 & 6x9 in. speaker “SP 6*9/6”
For the OEM speaker “SP OEM”
4 Exit Speaker Setting mode
Press the [VOL] knob.
Switching Display
Changing the information displayed.
1 Enter Switching Display mode
Press the center of the Control knob for at least
1 second.
“DISP SEL” is displayed.
2 Select the Display item
Press the right or left side of the Control knob.
In Tuner source
Information Display
Program Service name or Frequency “FREQ”/ “FREQ/PS”
Radio text, Program Service name or Frequency* “R-TEXT”
Clock “CLOCK”
* This is not displayed on the KDC-W241/KDC-241.