Kenwood KAF-1030 Stereo Amplifier User Manual


 
8
KAF-3030R/1030 (En)
+
+
SPEAKERS
(A or B : 4–16, A and B : 8–16)
R
A
B
L
PHONO
MD/CD-R
TAPE
REC
PLAY
REC TUNER AUX
Adv. DA
/CD
SYSTEM
CONTROL
PLAY
SIGNAL
GND
L
R
Connect the speakers as shown below, ensuring that bare wires do not make contact with other terminals.
Speaker impedance
When only one pair of speakers is connected to A or B speaker terminals, use the speakers having an impedance of 4 to
16 .
When two pairs of speakers are connected to both A and B terminals simultaneously, use the speakers having an
impedance of 8 to 16 . In this case, connecting a speaker having an impedance of less than 8 may cause malfunction
of the amplifier.
1 Strip coating.
3 Insert.
2 Loosen.
4 Secure.
Speaker system B
Never short-circuit the + and – speaker cords.
If the left and right speakers are connected inversely or if the
speaker cords are connected with reversed polarity, the sound
becomes unnatural with ambiguous acoustic image positioning.
Be sure to connect the speakers and speaker cords correctly.
1 Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
3 Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
Speaker system A
RIGHT
LEFT
·ª·ª
·ª·ª
Notes
Notes
Connection of speakers
RIGHT
LEFT