Filter
Top Products
Recording on TAPE
27
EN
5. Start recording.
4. Select the source to be recorded.
Select an input source other than
"TAPE"
1 Press the rec key.
2 Play (or tune) the input source to be recorded.
÷ Recording stops automatically when the tape side (s) to be recorded have
been fully recorded.
CD
TUNER (Broadcasts)
AUX (External input) [Adjusting the AUX input level fl]
÷ If a CD has already
been loaded, it starts to
play now. Press the 7
key to stop it.
Pause the recording
÷ Press the rec key during recording. It pause after
leaving a non-recorded blank of 4 seconds. (Press
the key again to resume recording.)
Lights
Stop the recording
Select the reverse mode. (
3. Set the recording condition.
÷ Check the tape transport direction before starting recording. If it is set to
the reverse direction, only one side of tape can be recorded regardless of
the reverse mode setting made here.
÷ The tape equalizer is defeated during recording.
The character information display shows the re-
cording input source.
\
\
\
\
Example:
To select the CD input
1 "BEAT CANCEL ON" :
(Beat Cancel is activated)
2 "BEAT CANCEL OFF" :
(Beat Cancel is deactivated)
Each press switches the modes as follows.
While recording from tuner input, beat sound can be minimised by
pressing the set/demo key.