Kenwood DPX-MP4110 CD Player User Manual


 
8
|
DPX-MP5110U/DPX-MP4110/DPX-MP3110
General Operation
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type Display
OFF “SP Off”
For 5 & 4 in. speaker “SP 5/4”
For 6 & 6x9 in. speaker “SP 6*9/6”
For the OEM speaker “SP OEM”
1 Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2 Enter Speaker Setting mode
Press the Control knob.
“SP SEL” is displayed.
3 Select the Speaker type
Turn the Control knob.
4 Exit Speaker Setting mode
Press the Control knob.
Sound Enhancer Select
You can play back adding gorgeous heavy bass to
the sound.
1 Enter the Sound Effect mode
Press the [SE] button.
"SE SEL" is displayed.
2 Select the Sound effect item
Turn the Control knob.
Sound effect Display
Returns to the normal sound without Sound effect. “SE Off“
Moves the sound image up a notch and adjusts bass
“SE Low”
Moves the sound image up two notches and adjusts
bass.
“SE High“
Changes to the value set in <Sound Enhancer
Control>(page 9).
“SE User“
When the Sound effect is ON, the SE indicator is
ON.
3 Exit the Sound Effect mode
Press the [SE] button.
Audio Setup
You can set Sound system, such as follows;
Adjustment Item Display Range
Front High Pass Filter “HPF” Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter “HPR” Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter “LPF” 50/60/80/100/120/Through Hz
Subwoofer Phase “PHAS” Reverse (180°)/ Normal (0°)
Volume offset “V-Off” –8 — ±0 (AUX: -8— +8)
Loudness “LOUD” Off/On
Dual Zone System “2ZON” Off/On
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by “Zone2” of <Menu
System> (page 14).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by Control knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 7).
- The Audio Control has no effect on sub source.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the Control knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the Control knob.
4 Adjust the Audio setup item
Turn the Control knob.
5 Exit Audio Setup mode
Press the Control knob for at least 1 second.