Filter
Top Products
DPF-J5020 (En)
6
System connections
COAXIAL
DIGITAL
OUT
SYSTEM CONTROL
COAXIAL
DIGITAL
OUT
OPTICAL
L
R
OUTPUT SYSTEM
CONTROL
SL16 XS 8
L
R
CD
Notes
Notes
System connections
Make connections as shown below.
When connecting the related system components, refer
also to the instruction manuals of the related components.
Do not plug in the power lead until all connections are com-
pleted.
Be sure to use this unit placed on a level surface.
Malfunction of microcomputer
If operation is not possible or erroneous display
appears even though all connections have been
made properly, reset the microcomputer refer-
ring to “In case of difficulty”. ⁄
Optical connection
(Except for the U.S.A., U.S. Military and Canada)
Optical fiber cable (Commercially-available)
To OPTICAL terminals
like receiver, MD, DAT,
etc.
Remove the protection cap
when using the DIGITAL
OUT (OPTICAL) jack.
SL 16/XS8 switch
7
System control cord
To wall AC
outlet
Audio cord
Digital amplifier or receiver, etc.
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Digital component (MD,DAT, etc.)
DIGITAL INPUT (COAXIAL)
75Ω coaxial cable with RCA PIN (Commercially-available)
75Ω coaxial cable with RCA PIN
(Commercially-available)
DTS Disclaimer clause
When playing DTS-encoded CDs, excessive noise will be exhib-
ited from the analog stereo outputs. To avoid possible damage
to the audio system, the consumer should take proper pre-cau-
tions when the analog stereo outputs of the CD player is con-
nected to an amplification system. To enjoy DTS Digital Sur-
round™ playback, an external 5.1 channel DTS Digital Surround™
decoder system must be connected to the digital output (S/PDIF,
AES/EBU, or TosLink) of the CD player.