Filter
Top Products
18
DPF-3010/2010/1010 (En)
The following procedure allows to record a CD within the
specified tape length so that no music is interrupted in the
middle at the ends of sides A and B.
Editing
Preparation
: Keys and control used in the operations described on this page.
Press the numeric keys as shown below.
30-minute tape : 000)
46-minute tape : 00006
1
Light the “EDIT” indicator.
2
Do this operation in the stop mode.
Go to step 2 within 5 seconds.
If more than 5 seconds have elapsed,
press the key again.
Blinks.
÷Recording within 99 minutes can be specified in minutes (2 digits).
÷While you can edit with a different time setting to that of the tape you
are using, part of the tape may be left with nothing recorded on it, or the
last track on side A or side B may be cut short.
Lights up.
Lights up.
Enter the recording time of the tape.
The CD contents are edited as follows.
(1) The tape recording time input is divided by two, and tracks that can
be accommodated in file A (which refers to tracks on tape side A) are
selected in order of their track Nos.
(2) In a few seconds, the time left on tape side A is displayed, then file
B (tracks on tape side B) is edited in the same manner.
÷The EDIT function may not operate properly for discs having only one
track or having tracks of long duration such as classical music.
(“no FILE” is displayed.)
Press the 6 key to start playback according to the edited content. The
playback pauses at the beginning of the track edited for tape side B. Press
the 6 key again to continue playback.
When recording the edited content onto a tape, it is recommended to
use the synchro recording or CCRS recording function of KENWOOD
cassette decks.
÷Do not adjust the output level from this unit particularly during record-
ing.
÷For details, see the instruction manual of the cassette deck.
Playing or recording the edited contents
1¡
4
76
¢
EDIT
PGM
C_ __
EDIT
0
+
10
7 8 9
4 5 6
1 2 3
The figure shows an example for the DPF-3010
÷ Load a disc in the CD player.
@