Kenwood DPF-1010 CD Player User Manual


 
8
DPF-3010/2010/1010 (En)
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically switches the input selector on the amplifier or receiver when you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from CD. Also, the simple CCRS operation lets you make great recordings
from CD.
See the operating instructions supplied with your cassette deck and MD recorder for details.
SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD
audio component system lets you take advantage of convenient
system control operations.
There are two KENWOOD system control modes. Make connec-
tions according to the groups of terminal symbols shown below.
[XS8] Mode : lets you combine F, f, and ƒ terminals
[SL16] Mode : for
terminals only
This unit is compatible with both [XS8] and [SL16] modes.
÷ When all units in system control connection are set to [XS8]
mode, set the SYSREM CONTROL selector switch on the rear
to the [XS8] side and connect.
÷ When all units in system control connection are set to [SL16]
mode, set the SYSREM CONTROL selector switch on the rear
to the [SL16] side and connect.
÷Do this operation after completing all connections.
(Ensure that the unit is set to STANDBY mode.)
1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8]
equipment for system operations. If your equipment consists of this
kind of combination, please do not connect any system control cords.
Even without system control cords, normal operations can be car-
ried out without affecting performance.
2. If your amp or receiver does not have a system control terminal, do
not connect any system control cords to the system control terminals
on the other components.
3. Do not connect system control cords to any components other than
those specified by Kenwood. It may cause a malfunction and damage
your equipment.
4. Be sure the system control plugs are inserted all the way in to the
system control terminals.
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
SYSTEM
CONTROL
SL16 XS 8
j
SYSREM CONTROL
selector switch
Notes
Notes