Filter
Top Products
15
DPF-3010/2010/1010 (En)
÷When a track No. is selected, the track will be added to the end of the
existing program.
Press to clear tracks from the end.
To check or change the programmed tracks
To clear tracks from the program
1 Press the CHECK key.
Press until the track No. to
be changed is displayed.
2 Select the new track No.
Auto space function
During programming of tracks, a non-recorded space of a few
seconds will be automatically created between tracks. By recording
tracks with these spaces on tape, the search and repeat play
operations of tape using the DPSS function (which works by
searching the non-recorded spaces) can be performed reliably.
÷Even when the performances of two tracks are continuous (which
occurs with classical or live recording music), the spaces will be
created if they have different track numbers.
÷Each time the key is pressed, the last track in the program is cleared.
÷The tracks which are programmed earlier than the track being played
cannot be cleared.
÷Selected tracks can be also completely cleared just by operating the 0
key.
÷The entire program is cleared.
3 Set the entry.
÷Perform only step 1 to simply check the program.
÷Each time the key is pressed, the program No. (P-No.) and the track No.
on CD are displayed.
÷The previous display resumes in a few seconds.
÷Press it while the “P.C.” indicator is lit.
÷The track being played cannot be changed.
To clear all track.
Lights up.
To add a track to the program
1 Select the desired track No.
2 Press the P.MODE key.
CHECK
0
+
10
7 8 9
4 5 6
1 2 3
P.MODE
0
+
10
7 8 9
4 5 6
1 2 3
CLEAR
P.MODE
TRACK
NO.
P.C.
6
3
PGM
06
P_ 02