Kenwood DPF-1010 CD Player User Manual


 
14
DPF-3010/2010/1010 (En)
Programmed play (PGM mode)
Use the following procedure to program desired tracks in a
desired order. (up to 20 tracks)
÷ Load a disc in the CD player. @
Press so that the “PGM” indicator lights.
Program desired tracks.
1
2
Preparation
: Keys and control used in the operations described on this page.
÷The programmed contents remain in memory.
To stop playback
Start playback.
3
÷When the 4 or ¢ key is pressed during playback, the track will be
skipped in the direction of the pressed button.
÷When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
Lights up.
Displays the total playing time
of the programmed tracks.
÷Up to 20 tracks can be programmed. When “FULL” is displayed, no
more tracks can be programmed.
÷If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
÷When the total playing time of the programmed tracks exceeds 100
minutes, the remaining time on the disc will not be displayed any more.
2 Set the entry.
1 Select the desired track No.
Press the numeric keys as shown below....
To enter track No. 25: 005
Go to step 2 within 5 seconds.
3 Repeat steps 1 and 2 above.
Do this operation in the stop mode.
Displays the entered program No.
for a few seconds.
P.MODE
0
+
10
7 8 9
4 5 6
1 2 3
P.MODE
6
PLAY/PAUSE
7
STOP
TRACK
NO.
02
P_ 01
TRACK
NO.
TOTAL TIME
0
_
:
2
16 42
TRACK
NO.
PGM
01
4
76
¢
The figure shows an example for the DPF-3010