Filter
Top Products
9
C-V351/C-V301 (EN)
ON/STANDBY
PHONES
INPUT TAPE 2
(MONITOR)
VOLUME CONTROL
DOWN
UP
AV CONTROL CERTER KC-2
CLOCK
TIMER
MODE
RDS
PTY
DISPLAY
TIMER
SET
S.DIRECT
TA/NEWS/INFO.
STEREO
DSP
A.MEMO
AUTO BAND
TUNING
PTY SELECT
MODE
MULTI.CONTROL
LEVEL
OPEN/CLOSE
1
3
(¡ ™)£¢
AUTO
RDS
EON
PTY
TIMER
NEWS
INFO.
FM
LW
MW
TATP
PRO LOGICPRO LOGIC
3 STEREO
DSPDSP
TAPE 2
STEREO
TUNED
MUTE
SLEEP
dB
ms
MHz
kHz
1
2
SOURCE
DIRECT
MEMO
4
0
9
8
765
!
@
#
$^%
&
*
2
The keys which have the same names as the controls on the
remote control unit provide the same functions as them.
$TIMER MODE key
Press to switch the timer modes.
%S.DIRECT key
Press to switch the Source Direct function
which allows to reproduce the source with
a better quality.
^RDS DISPLAY key
Press to switch the RDS display.
&RDS PTY key
For use during reception of RDS broadcast-
ing.
*RDS TA/NEWS/INFO. key
For use during reception of RDS broadcasting.
(A.MEMO key
Press when using the auto memory func-
tion.
)AUTO key
Press to select the tuning mode.
The auto tuning or manual tuning mode can
be selected.
The input selection display of a source can
be switched to another by pressing and
holding the AUTO key for more than 2
seconds.
0
1
(ON/STANDBY) key
Press to switch between ON and STANDBY.
2 Remote sensor
3 TIMER SET key
Press to set the timer function.
4CLOCK key
Press to set the clock.
5STEREO key
6DSP key
7DOLBY key
8MODE key
Press to switch various setting modes.
9MULTI.CONTROL key
Press to select various setting modes.
0GRC transmitter
Outputs the signals transmitted to the
Graphical Remote Control.
!PHONES jack
For use in headphones listening.
@INPUT SELECTOR key
Press to select the input.
#TAPE 2 (MONITOR) key
For use in monitoring of recording, etc.
¡BAND key
Press to switch the broadcasting band.
™TUNING key ( , )
Press to select the radio station to be re-
ceived.
These keys are also used in the clock adjust-
ment and timer operations.
£OPEN/CLOSE key
¢VOLUME CONTROL knob
MEMORY indicator
RDS indicators
(RDS, TP, TA, EON, PTY, NEWS, INFO.)
Frequency display, input
selector display, preset
channel display, surround
mode display
Decibel indicator
Delay time indicator
DSP indicator
TAPE 2
indicator
AUTO tuning mode/AUTO stereo
reception indicator
STEREO indicator
TUNED indicator
MUTE indicator
SOURCE DIRECT indicator
SLEEP
TIMER
indicator
PRO LOGIC
indicator
3 STEREO
indicator
Receiving frequency
unit indicators
Display
TIMER
indicators
Broadcast band
indicators
Standby mode
While the standby indicator of the unit is lit, a small amount of current is flowing into the unit’s internal circuitry to back up the memory. This condition
is referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit.
With this unit, standby mode is indicated by means of the display panel. The system is in standby mode while the clock display is shown.
Controls and indicators