Filter
Top Products
6
System connections
Caution:
Do not plug in the power lead until all connections are com-
pleted.
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to “In case of difficulty”.
™
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution
Be sure to adhere followings. Or proper ventilation will be blocked causing damage or fire hazard.
÷ Do not place any objects impairing heat radiation onto the top of unit.
÷ Leave a space around the unit (from the largest outside dimension including projection)
equal or greater than, shown below.
Top panel : 50 cm Side panel : 10 cm Back panel : 10 cm
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Notes
Notes
Commercially-available
optical fiber cable
System control cord
Audio cord
Amplifier
Remove the
protection cap
when using the
DIGITAL OUTPUT
(OPTICAL) jack.
To wall AC outlet
To AC outlet
To AC outlet
MD recorder/CD-R
DIGITAL OUTPUT jack
OUTPUT
OPTICAL
DIGITAL
OUTPUT
SYSTEM CONTROL
L
R
SYSTEM
CONTROL
L
R
CD
DIGITAL
INPUT
OPTICAL
TEXT
Connection to KENWOOD CD TEXT MD recorder;
The text (track titles) and the music of a CD can be copied to an MD.
For details, refer to the MD instruction manual.