Filter
Top Products
INITIAL SETTING
21
The matching of the satellite receiver to the satel-
lite receiving installation is carried out in the Initial
Setup Menu.
The receiver has however already been factory-
preprogrammed for standard satellite receiving
installations
Changes to the initial settings are therefore
only necessary if your receiving installation dif-
fers from these types of installation.
These settings are generally carried out by the
specialist dealer during installation of the satellite
receiving system. You do not therefore need to be
too concerned about this section!
The Initial Setup Menu is divided up into 4 sub-
menus with the following menu entries.
See also Menu Structure in the appendix!
⇒ General Menu
• LNB supply
• LNB supply in standby
• LNB voltage step-up
• Language
• Program selection
⇒ Oscillator Menu
• LO 1 to LO 4
⇒ DiSEqC Menu
• 22 kHz signal
• Tone burst
• Full DiSEqC
⇒ Search Menu
• Search
• Frequency band
• Orbit position
• Oscillator
Calling the Initial Setup Menu:
To prevent unintentional alteration of the initial set-
tings, the Initial Setup Menu can only be called up
from the switched-off state (switched off at the
power button on the unit).
Call-up:
1. Simultaneously press both the program selec-
tion keys
on the receiver and hold the
keys pressed.
2. Switch on the unit with the power button.
3. Release the
keys when the following
appears in the LCD display.
General Menu
entry --> (OK)
The setting in the Initial Setup Menu is carried out
in the same way as for the normal setup menu
during station programming.
• Selection of main menus and submenus using
the keys
.
• Call-up of a submenu and activation of the indi-
vidual menu entries with
OK
Active menu entries are indicated by
< ........>
.
The setting can now be carried out.
• Setting of program data using the keys
(and the numeric keys 0-9 for oscil-
lator frequency input).
• Return using the key
BACK
.
• Storing of the input with
OK
On quitting a menu entry the following query ap-
pears in the LCD display
Store?
YES>OK NO>BACK
Explanation of the menu entries:
General menu
LNB supply voltage
Here you are able to turn off the power supply for
the feeder system if the feeder system works off an
external power supply.
Presetting:
ON
LNB supply voltage in Standby
When the receiver is in standby the LNB supply
voltage is normally switched off. If the power sup-
ply to the components for intercoupling of satellite
signals and terrestrial antenna signals is effected
from the receiver, the power supply for the feeder
system must also be ensured when the receiver is
in standby. In this case switch the power supply in
standby to "
On
".
Presetting: "
Off
".
LNB voltage step-up
If problems occur during polarization changeover,
e.g. due to a very long antenna line or unfavorable
tolerances in the distribution system with multi-user
systems, you can increase the LNB supply voltage
by approximately. 0.5-1 V.
Presetting:
OFF