Jwin JX-CD280 CD Player User Manual


 
2
they are used for the first time or they have not been used for
a long period of time (over 60 days).
1. Open the battery compartment cover and insert two of the
recommended rechargeable batteries, matching polarity.
(1.2V 650mA).
ALL BATTERIES MUST BE OF RECHARGEABLE NICKEL-CADMIUM
TYPE, OTHERWISE THE BATTERIES MAY EXPLODE OR LEAK.
2. Plug in the AC adapter. (NOT INCLUDED)
3. Slide the charge switch to CHARGE position to start charg-
ing.
USE ONLY THE AC ADAPTER FOR CHARGING. (NOT IN-
CLUDED)
4. After 15 hours, please unplug the AC adapter and slide the recharge switch to
normal position.
DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO CAN CAUSE
THE PERFORMANCE OF THE RECHARGEABLE BATTERIES TO DETERIORATE.
NOTE: You may play DISC’S whilst charging the batteries.
If the operating time decreases drastically even when the rechargeable nickel-
cadmium batteries are properly recharged, purchase a new set of rechargeable
nickel-cadmium batteries. When charging for the first time or after a long time, playing
time may be reduced. In this case, charge and discharge the batteries several
times.
NOTE ON ALKALINE BATTERIES
1. When replacing the alkaline batteries, use two new batteries of the same type.
Do not mix a used battery with a new one or mix different types of batteries.
2. When inserting the batteries, be sure to place the batteries as the sketch shown,
mistakenly inserting even one with improper polarity will cause leakage and the
unit will not play properly.
3. When not using the unit for an extended period of time, or not use the batteries
for a long time, remove them to prevent possible acid leakage or corrosion re-
sulting in damage to your player or personal injury such as skin burns.
4. Bear in mind that battery life expectancy is based upon playing mode. Maxi-
mum battery power consumption happens at maximum settings. If sound gets
distorted or if the unit fails to switch tracks, your batteries are weak. Replace both
batteries, or use AC adaptor. (ADAPTOR NOT INCLUDED)
5. Never charge, heat, disassemble, or throw batteries into a fire.
6. If the display shows the symbol “
”, this means your batteries are weak, re-
place them or use the AC adaptor. (ADAPTOR NOT INCLUDED)
7. If the display is blank - no numbers show when power is turned on, the batteries
are dead.
Replace them or use the AC adapter. (ADAPTOR NOT INCLUDED)
AUTO POWER ON FUNCTION
The power turns on automatically when the PLAY/PAUSE button is pressed.
AUTO POWER OFF FUNCTION
The power turns off immediately after the disc compartment is opened.
When all the tracks on a disc have been played, or the Stop button is pressed, the
power turns off automatically within 60 seconds if no button is pressed.
If you pressed the Stop button twice the power will turn off
OPEN
CHARGE SWITCH