Filter
Top Products
Setting DVDpreferences
peaker setting menu (SPK.SETTING)
• Levelmenu(LEVEL)
FRONT LEFT SPEAKER/FRONT RIGHT SPEAKER/CENTER
SPEAKER/SURROUND RIGHT SPEAKER/SURROUND LEFT
SPEAKER
While monitoring the test tone, adjust the center and surround
speakers volume as nmch as that of the front speakers.
Yuu can adjust the output level in the -6 dB to +6 dB range.
TEST TONE*
Outputs the test tone.
* The test tone comes out of all of the activated s _eakers in the
fbllowing sequence:
=> Front left speaker =:5 Center speaker _ Front right
speaker :=> Surround right speaker :=> Surround left speaker
:=> (back to file beginning)
NOTE
• Adjustnient of subwoof_r output level is not available.
• Delaymenu (DELAY)
Example:
Center speaker
Front
0 ms
/ / /
i i ,'
i '
Surround le_
2 ms
1ms increase (or decrease) in delay time corresponds to about
30 cm (1 ft) decrease (or increase) in distance.
Set to "0 ills" for the furthest speaker from your position as the basis
for the delay time setting.
In this case, set the dehly time of each speaker as follows;
• Delay time of front speakers: 0 nls
• Delay time of center speaker: 1 nls
• Delay time of surround speakers: 2 nrs
FRONTLEFTSPEAKER/FRONTRIGHT SPEAKER/CENTER
SPEAKER/SURROUNDRIGHTSPEAKER/SURROUNDLEFT
SPEAKER
Adjust the distance from the listening positiou to the speakers.
Within the r,'mge from 0 ms to 15 ms (by 1 ms).
• Subwoofermenu (SUBW00FER)
LEVEL
You can set the output level of the subwoofer ill the -6 dB to +6 dB
range.
CROSS OVER
The signals below the preset frequency level will be sent to and be
reproduced by the subwoofer.
Select one of the crossover frequency levels according to the size of
the small speaker connected.
• 120Hz: Select when the cone speaker unit built in the speaker is
about 8 cin (3-3/16 inches).
• 150Hz: Select when the cone speaker unit built in the speaker is
about 6 cm (2-3/8 inches).
• 200Hz: Select when the cone speaker unit built in the speaker is
about 5 cm (2 inches).
_: Other setting menu (OTHERS)
• RESUME
You cau activate or deactivate Resume Playback function. (See page
28.)
• ONSCREENGUIDE
You can activate or deactivate the on-screen guide icons. (See page
20.)
• DivX registrationmenu(DivXREGISTRATION)
Tile systenl has its own Registration Code fur DivX playback.
You can confirm the code of your system.
• Once you phly back a disc created by using the Registration Code,
the system's code is overwritten by a totally different new one for
copyright protection purpose.
35