JVC XV-THC3 Stereo Amplifier User Manual


 
7
Connections
7 AM (MW) loop antenna
Setting up supplied AM loop antenna
Connecting AM (MW) loop antenna
Turn the loop antenna until you have the best reception during
AM (MW) broadcast program reception.
NOTE
Make sure the antenna conductors do not touch any other terminals,
connecting cords and power cords. This could cause poor reception.
If reception is poor
7 FM antenna
If reception is poor
NOTE
We recommend that you use coaxial cable for the FM antenna as it is
well-shielded against interference.
Connecting the FM and
AM (MW) antennas
If the antenna cord is covered with the insulation
coat, twist and pull the insulation coat off and
remove.
1
Center unit
2
3
Antenna cord
Outdoor single vinyl-covered wire antenna
(not supplied)
AM (MW) loop
antenna
Center unit
Extend the supplied FM antenna
horizontally.
Center unit
FM antenna (supplied)
Outdoor FM antenna
(not supplied)
Outdoor FM antenna cord
(not supplied)
Center unit
Standard type (75 C
coaxial) connector
Do not connect the power cord until all other connections have been made.
TH-C3[B]_new.book Page 7 Thursday, May 19, 2005 1:52 PM