Filter
Top Products
25
To skip forward to the next music
Press the button same as the tape direction indicator as
follows:
3 ] Press ¢ button.
2 ] Press 4 button.
During Music Scan progressed, the tape direction
indicator starts blinking rhythmically.
Repeating Music Scan feature made easy
searching a desired program on a tape one after
another.
The beginning of the desired program may not be
located properly
If blanks between music are too short, the blanks
contain too much noise or the program itself
contains very low-level or silent part.
Playing Back Dolby-Recorded Tape
You can play back the tape recorded with Dolby B NR
system. The Dolby NR system allows to reduce hiss noise
in playback.
Press DOLBY B NR button on the cassette deck before
playback. Each time you press the button, the Dolby NR
lamp on the unit lights up orange or turns off.
A tape recorded using Dolby NR
Should be played back using the Dolby NR of the
same type as that used in recording. The audio quality
will be affected if a different type is used in playback.
Dolby noise reduction manufactured under license from
Dolby Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
5
Press 7 (stop) button to stop playback the tape.
6
Press 0 (open/close) button directly to stop and
remove the tape.
While the system is turned off (standby mode)
Pressing ` (playback) or TAPE ` (playback)
button automatically switches the system turned on
and starts playback if a tape is already loaded.
Fast-Winding a Tape
While stopping the tape, press 4 / ¢ button to fast-
wind the tape.
To fast-forward, if the current tape direction is:
3 ] Press ¢ button.
2 ] Press 4 button.
To fast-rewind, if the current tape direction is:
3 ] Press 4 button.
2 ] Press ¢ button.
During fast-winding, the tape direction indicator starts
blinking quickly.
When the tape comes to an end
The deck unit automatically stops.
Searching and Skipping to Each Program
— Music Scan
While playing the tape, you can search and skip to the
beginning of the current and next program on a tape.
Music scan searches for blank portions that usually
separate programs recorded onto the tape, then
automatically plays the program beginning after
that blank portion.
To skip backward to the current music
Press the button opposite to the tape direction indicator
as follows:
3 ] Press 4 button.
2 ] Press ¢ button.
REC
REC
o or
forward
reverse
REC
REC
o or
forward
reverse
Continued
EN24-32.UX-G66R[B]f 12/8/00, 8:03 PM25