Filter
Top Products
15
Presetting Stations
You can preset up to 30 FM and 15 AM (MW/LW) stations
into memory by following two methods: manual/automatic
presettings.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
To preset stations manually — Manual Preset
1
Press 4 / ¢ (lower/higher frequencies) button
to tune in the desired station manually.
2
Press SET button.
“SET” appears in the display window for a while (not
blinking).
• Note that “SET” message disappears, presetting
procedure is cancelled.
3
Rotate MULTI JOG dial or press repeatedly UP/
DOWN button to select the preset channel numbered
from 1 to 30 on FM, or 1 to 15 on AM.
• Note that the selected channel “02” disappears,
presetting procedure is cancelled.
4
Press SET button again.
“STORED” appears in the display window for a
while.
5
The tuned station in step 1 is now stored in the
preset channel selected in step 3.
Storing a new station on an used channel
erases the previously stored one.
Continued
To preset stations automatically — Auto Preset
You can automatically preset 30 FM, 15 AM (MW/LW)
stations. Preset numbers will be allocated as stations are
found, starting from the lowest frequency and moving up to
the higher frequency.
On the remote control only:
1
Press FM/AM button to select a desired band.
2
Press and hold AUTO PRESET button on the
remote control for more than two seconds.
The system automatically starts searching for stations
with the strong signals continuously, and they are stored
successively into memory as follows:
«
«
«
When you unplug the AC power cord
or if a power failure occurs
The preset stations will be erased in a few days.
If this happens, preset the stations again.
To change the FM reception mode
• When an FM stereo broadcast is hard to receive or noisy,
press FM MODE button on the remote control so that
MONO indicator lights in the display window. Reception
improves.
• To restore the stereo effect, press FM MODE button
again so that STEREO indicator lights in the display
window.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
EN14-23.UX-G66R[B]f 12/8/00, 8:03 PM15