Filter
Top Products
18
English
Recording the External Equipment — Sound Synchro-
nized Recording
Setting the recording mode, you can start playing back the
external equipment and recording from it onto an MD
simultaneously.
First of all, make sure the proper cable connections between
XM-G6 MD recorder and external equipment (see also page
6 in this manual, and refer to UX-G6’s Instructions page 9).
1
Insert a recordable MD.
The MD IN lamp lights orange.
2
Press AUX button to select either analog source or
digital source according to the external equipment.
Each time you press AUX button, AUX mode changes
between “AUX” and “AUX DIGITAL” alternately.
3
Press REC MODE button to select recording mode
as follows:
4
Press SET button to start recording from the external
equipment.
Selected source and remaining time for recording appear
in the display window as follows:
or
• To stop recording temporarily, press REC PAUSE
button or 6 (play/pause) button on the MD recorder
or MD 6 (play/pause) button on the remote control.
• To resume recording, press 6 (play/pause) button
on the MD recorder or MD 6 (play/pause) button
on the remote control again.
Each time you press DISPLAY/CHARA. button,
information switches between the remaining time for
the MD and the elapsed time for the MD alternately.
• If no sound comes in for more than 30 seconds, Sound
Synchronized Recording will stop. “WRITING”
appears in the display window, and you can remove the
MD by pressing 0 (eject) button.
AUX
AUX DIGITAL
EN11-18.XM-G6[U]/4 99.12.09, 15:5118