Filter
Top Products
8
Setting the Clock
Before operating the unit any further, first set the unit’s clock.
When you plug in the power cord, “0:00” starts flashing on
the display.
You can set the clock when the unit is either turned on or in
standby mode.
•There is a time limit in doing the following steps. If the
setting is canceled before you finish, start again from step
1
.
On the remote control ONLY:
1
When the unit is in standby mode,
press and hold DISPLAY/CLOCK
SET until the hour indication starts
flashing.
• When the unit is on, press DISPLAY/CLOCK SET to
enter clock mode, then press and hold DISPLAY/
CLOCK SET.
2
Press 4 or ¢ to adjust
the hour, then press
DISPLAY/CLOCK SET.
• When you press and hold 4 or
¢, the hour indication changes
continuously.
The minute indication starts flashing.
3
Press 4 or ¢ to adjust
the minute, then press
DISPLAY/CLOCK SET.
• When you press and hold 4 or
¢, the minute indication changes
continuously.
“CLOCK OK” appears on the display for a
while and the built-in clock starts.
Basic and Common Operations
DISPLAY/
CLOCK SET
Turning On the Power
To turn on the unit, press STANDBY/ON.
The standby lamp on the unit goes off.
•When you press the source button—TAPE,
TUNER/BAND and CD, the unit automatically
turns on.
To turn off the unit (standby), press STANDBY/ON
again.
The standby lamp on the unit lights red.
• “0:00” flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
•A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “0:00” right away. If this happens, set the clock
again.
STANDBY/ON
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to “0:00” right away. If this happens, set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY/CLOCK SET.
• Each time you press the button, the display
changes the clock indication and the normal
indication alternately.
To change the clock
Repeat steps
1
to
3
of the procedure “Setting the Clock.”
Continued
DISPLAY/
CLOCK SET
DISPLAY/
CLOCK SET
DISPLAY/
CLOCK SET
UX-S10[B]_C_05basic_f.p65 06.3.10, 5:17 PM8