Filter
Top Products
– 7 –
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Connect the AM (MW/LW) loop antenna to the AM
LOOP terminals as illustrated.
3
Turn the AM (MW/LW) loop antenna until you
have the best reception.
AM (MW/LW) antenna
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM (MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Connecting Speakers
To attach spacers
If you want to put the speakers on the side of the main unit,
you need to make a space between the main unit and the
right speaker for ventilation.
In this case, attach spacers (supplied) to the right speaker as
the illustration below:
Spacers (supplied)
The right speaker
By peeling the cover seal from spacers, you can attach
them to the right speaker.
The openings for ventilation
The main unit
To remove the speaker grilles
The speaker grilles are removable as the illustration below:
3
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop antenna
(supplied)
2
1
Speaker grille
Projections
Holes
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Also pull the
bottom towards you.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
EN01-09.UX-A70MDR[B]_f 00.12.4, 10:59 AM7