Filter
Top Products
Connections
8
Do not connect the power cord until all other connections have been made.
NOTE
• Place the satellite speakers on a flat and level surface.
• The front and center speakers are magnetically shielded to avoid color
distortions on TVs. However, if not installed properly, they may
cause color distortions. So, pay attention to the following when
installing the speakers.
– When placing the speakers near a TV set, turn off the TV’s main
power switch or unplug it before installing the speakers. Then wait
at least 30 minutes before turning on the TV’s main power switch
again.
Some TVs may still be affected even though you have followed the
above. If this happens, move the speakers away from the TV.
• The surround speakers and the subwoofer are not magnetically
shielded.
If it is located nearby the TV or monitor, it will probably cause
color distortion on the screen. To avoid this, do not place the
speaker nearby the TV or monitor.
• Be sure to place the subwoofer to the TV’s right side. If you place the
subwoofer to the TV’s left side, keep sufficient distance between
them to prevent the TV screen from appearing mottled.
• Distortion of picture may occur when connecting the TV via a
VCR, or to a TV with a built-in VCR.
• You need to set “MONITOR TYPE” in the PICTURE menu
correctly according to the aspect ratio of your TV. (See page 29.)
7 To connect a TV equipped with the component video
input jacks
NOTE
• If your TV supports progressive video input, you can enjoy a high
quality picture by setting the progressive scan mode to active. (See
page 12.)
• If the component video input jacks of your TV are of the BNC type,
use a plug adapter (not supplied) to convert the pin plugs to BNC
plugs.
• The video signals can be output only when you select “DVD” as the
source to play. (See page 11.)
7 To connect a TV equipped with the S-VIDEO and/or
the composite video input jacks
NOTE
• Select the appropriate scan mode according to your TV. (See page
12.)
You can enjoy the sound of an analog component.
NOTE
• If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this system, the sound output
through this system may be distorted.
• When playing a video component such as a VCR;
• To listen to the sound, select “AUX” as the source to play. (See
page 11.)
• To see the picture, connect the video output jack of the component
to the video input jack of the TV directly, and select the correct
input mode on the TV.
Make sure that all other connections have been completed.
CAUTION
• Disconnect the power cord before cleaning or moving the system.
• Do not pull on the power cord to unplug the cord. When unplugging
the cord, always grasp and pull the plug so as not to damage the cord.
NOTE
• Preset settings, such as preset stations and surround mode adjustment,
may be erased in a few days in the following cases;
• If you unplug the power cord of the center unit.
• If a power failure occurs.
Speaker layout
Connecting a TV
Front right
speaker
Center speaker
Subwoofer
Surround left
speaker
Surround right
speaker
Front left
speaker
Center unit
To component
video input
TV
Component video cord (not supplied)
Connecting an external
component
Connecting the power
cord
Center unit
TV
S-VIDEO cord
(not supplied)
Composite video cord
(supplied)
RCA pin plug cord
(not supplied)
Center unit
VCR
TV
Cassette recorder
To audio output
Center unit
Power cord
Plug into AC outlets.
TH-S11B[J].book Page 8 Tuesday, May 8, 2007 4:15 PM