JVC TH-M303 Home Theater System User Manual


 
Advanced operations
37
IMPORTANT
Before using the remote control for the following
operation;
Set the remote control mode selector to
AUDIO.
NOTE
Before you start operation;
There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
1 Press SETTING.
Example:
2 Press Cursor Y/5 to select the item
you want to set.
BAL (Balance):
You can adjust the balance between the front left and front
right speakers.
DEC (Decode):
When you play an external source (DBS is selected as a
source) that was encoded with Dolby Digital or DTS Digital
Surround, the following symptoms may occur;
No sound comes out at the beginning of playback.
Noise comes out while searching for or skipping chapters
or tracks.
AUT/PCM (Auto/PCM):
Normally select this. The system automatically
detects the incoming signals.
DOLBY D: Select this if the symptoms above occur when
playing a disc (or software) encoded with
Dolby Digital.
DTS: Select this if the symptoms above occur when
playing a disc (or software) encoded with DTS
Digital Surround.
M. OUT (Monitor Out):
Select the video output jack type by which you watch DVD
playback after connecting your TV. (A pg. 14)
Set the video output to use AV COMPU LINK remote
control system. (A pg. 44)
VIDEO: To watch DVD playback via the VIDEO jack.
S: To watch DVD playback via the S-VIDEO jack.
COMPNT (component):
To watch DVD playback via the COMPONENT
VIDEO OUT jacks.
DiscIll (For TH-M606/TH-M603/TH-M505/TH-M501):
When you select DVD as the source and leave the system in
stop mode for 5 minutes, the disc lamps starts illuminating.
3 Press Cursor 3/2 to make an
adjustment or selection.
Example:
The adjustment is set and display automatically disappears a
few seconds later.
NOTE
When “DOLBY D” or “DTS” is selected, if a signal encoded with
another digital format comes in, you cannot listen to the sound. (The
GDIGITAL or C indicator flashes.)
Sound and other settings
BAL : CENTER
BAL : R
--
5
See page 26 for button locations.