Filter
Top Products
Connections
12
Note that the illustration below is for SP-PWC6.
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
Precautions for daily use
• When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
• Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
(For TH-C6)
• When holding a speaker, always grasp the lower portion.
• Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
CAUTION:
SPEAKER IMPEDANCE
4
Ω
16
Ω
• Connect the black cords to the black (r) terminals.
• Connect the white cords to the (q) terminals
referring to the table below:
Speaker cord
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
TH-C6: SP-PWC6
TH-C3: SP-PWC3
Front speakers
TH-C6: SP-THC6F
TH-C3: SP-THC3F
Surround speakers
TH-C6: SP-THC6S
TH-C3: SP-THC3S
Center speaker
TH-C6: SP-THC6C
TH-C3: SP-THC3C
Do not connect the power cord until all other connections have been made.
This page is except for TH-C9.
TH-C3C6C7C9[AUWUSUNUGUX].book Page 12 Monday, April 25, 2005 8:56 PM