JVC TH-C9 Home Theater System User Manual


 
Connections
11
CAUTION
When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
DO NOT connect more than one speaker to one speaker terminal.
Precautions for daily use
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
When holding a speaker, always grasp the lower portion.
Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
Connect the black cords to the black (r) terminals.
Connect the white cords to the (q) terminals referring to the table below:
Speaker cord (supplied)
Before connecting the
speaker cords;
Twist and pull the insulation coat
off and remove.
Powered subwoofer
TH-C9: SP-PWC9
Surround speakers
TH-C9: SP-THC9S
Center speaker
TH-C9: SP-THC9C
Front speakers
TH-C9: SP-THC9F
4m 10m
4m
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Do not connect the power cord until all other connections have been made.
This page is for
TH-C9
TH-C3C6C7C9[AUWUSUNUGUX].book Page 11 Monday, April 25, 2005 8:56 PM