Filter
Top Products
46
Tuner Operations
RDS allows FM stations to send an additional signal along with their
regular program signals. For example, the stations send their station
names, as well as information about what type of program they
broadcast, such as sports or music, etc.
When tuned to an FM station which provides the RDS service, the
RDS indicator lights up on the display.
Notes:
• RDS is not available for AM broadcasts.
• RDS may not operate correctly if the tuned station is not
transmitting RDS signals properly or if the signal strength is weak.
Using the RDS (Radio Data System)
to Receive FM Stations
What information can RDS signals provide?
You can see the following RDS signals the station sends on the
display.
PS NAME (Program Service):
While searching, “PS NAME” appears, then the station names will
be displayed. “NO PS” appears if no signal is sent.
RT (Radio Text):
While searching, “RT” appears, then text messages the station sends
will be displayed. “NO RT” appears if no signal is sent.
CT (Clock Time):
While searching, “CT” appears, then clock signals the station sends
will be displayed. “NO CT” appears if no signal is sent.
Frequency:
Station frequency (non-RDS service)
From the remote control ONLY:
Make sure that the remote control is for the tuner operation. If not,
press FM/AM on the remote control so that the remote control can
be used for the tuner operation.
Press RDS DISPLAY while listening to an FM
station to show the RDS signals.
• Each time you press the button, the display changes to
show the following information:
To check the PTY, press PTY SEARCH once so that the current
PTY code appears.
•“NO PTY” appears if no signal is sent.
About characters shown on the display
When the display shows PS NAME, RT, or CT signals, the
following characters are used.
• The display cannot differentiate upper case and lower case letters
and always uses upper case letters.
• The display cannot show accented letters, “A,” for instance, may
stand for accented “A’s” like “Å, Ä, Ã, Á, À, Â, å, ä, ã, á, à, and
â.”
Note:
If searching finishes at once, “PS NAME,” “RT,” and “CT” will not
appear on the display.
PS NAME RT
CTNormal indication
(Frequency)
1
RDS DISPLAY
RDS indicator
PTY –
PTY SEARCH
ENTER
VOLUME
DVD FM/AM AUX MUTING
REMAIN
PROGRAM
D.R.C
SETUP
SLEEP
EFFECT
DSP MODE
TEST
PRO LOGIC
SETTING
SOUND
PTY –
RDS DISPLAY
PTY SEARCH PTY +
TA
CLEAR
REPEAT
ANGLE
SLOW
SEARCH
A-B REPEAT
ZOOM
123
45
6
78
9
0
RDS DISPLAY
PTY +
If the remote control is not for the tuner operations, the
button for the RDS operations—RDS DISPLAY, TA, PTY +
and –, and PTY SEARCH—do not work. In this case, press
FM/AM on the remote control so that the remote control can
be used for the tuner operation.
Then, the display shows its PS name.
EN44-49TH-A5[B]f.pm6 01.11.20, 11:4346