Filter
Top Products
– 8 –
English
OPTICAL DIGITAL
OUT
RL
AUX
L
R
L
R
Speaker grille
To remove the speaker grille, insert your fingers at the top
of the speaker grille, pull towards you. Then pull the bottom
towards you.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
Connecting Other Equipment
You can connect both of the analog and digital equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect audio equipment
Be sure that the plugs of the audio cords are colored: White
plugs and jacks are for left audio signals, and red ones for
right audio signals.
Holes
Projections
To remove the speaker grilles
The speaker grilles are removable.
To audio output
Audio equipment
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX jacks by using audio cords (not
supplied).
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
Before connecting the other
equipment, remove the protective plug
from the terminal.
Protective plug
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
OPTICAL DIGITAL OUT terminal.
To connect a TV set
You can connect a TV with a video input jack: used as a
monitor for video CD playback.
To optical digital input
Audio equipment with
an optical digital input
Auxiliary Equipment
RL
OPTICAL DIGITAL
OUT
SPEAKER
IMPEDANCE
MIN
6
RIGHT LEFT
SPEAKERS
VOLTAGE
SELECTOR
110V
127V
220V
230V
-240V
AM EXT
FM
COAXIAL
AM LOOP
75
ANTENNA
AUX
To video input
TV
VOLTAGE
SELECTOR
110V
127V
220V
230V
-240V
Voltage mark
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the voltage
where you are plugging in the unit. (See the back cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
Now, you can plug the AC power cord.
• If the wall outlet does not match the AC plug, use the
supplied AC plug adaptor.
IMPORTANT: Be sure to check all connections to be
done before plugging the AC power cord into a wall outlet.
EN01-14_UX-L46&36[US&UJ]f 28/5/2002, 3:58 PM8