Filter
Top Products
14
(2) Select a track.
4 Confirm the selection.
Next program step is indicated.
5 Repeat steps 3 and 4 to program the other tracks.
6 Start playback.
The tracks you have selected are played back in the order
you have programmed.
• You cannot select the track with the number buttons during
Program Play.
To check the programmed contents
While the PROG. indicator lights up on the display and
playback is stopped...
To modify the program
While the PROG. indicator lights up on the display and
playback is stopped...
To skip a track: To pause: To stop:
or
To release, press
again.
MP3 CD
PROG.
Track number
PRESET
DISPLAY/
PROGRAM
MP3 CD
PROG.
Program step
Group number
MEMORY
USB
or
CD
PRESET
CD
MEMORY
USB
STOP
Edit:
1 Press DISPLAY/PROGRAM repeatedly until the
program step you want to edit is displayed.
2 Perform the steps 3 and 4 on pages 13 and 14.
To add step in the program:
1 Press DISPLAY/PROGRAM repeatedly until “00” is
displayed.
2 Perform the steps 3 and 4 on pages 13 and 14.
To erase entire program:
The PROG. indicator goes off.
Program contents are also erased in the following cases:
• When you open the CD door while the source is disc.
• When you disconnect the USB mass storage class device
while the source is USB mass storage class device.
• When you start Random Play.
• When you change the source.
• When you turn off the System.
DISPLAY/
PROGRAM
STOP
UX-G200[J].BOOK Page 14 Tuesday, December 2, 2008 3:05 PM