Filter
Top Products
8
Listening to the Radio
To select the band (FM or AM)
From the remote control:
On the main unit:
To tune in to a station
While FM or AM is selected...
Station searching starts and the frequency indication starts
changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the searching will stop.
To stop searching manually,
press either button.
• When you press the button repeatedly, the frequency
changes step by step.
If the received FM station is hard to listen
From the remote control:
On the main unit:
Reception will improve though stereo effect is lost.
The MONO indicator lights up.
To restore the stereo effect,
press the button repeatedly to
select FM.
To preset the stations
You can preset 20 FM and 10 AM stations.
1 Tune in to a station you want to preset.
2 Activate the preset number entry mode.
• Finish the following process while the indication on the
display is flashing.
3 Select a preset number for the station.
4 Store the station.
To tune in to a preset station
1 Select a band (FM or AM).
From the remote control:
On the main unit:
2 Select a number of the preset station.
FM FM MONO
AMA_IN
FM/AM/
AUDIO IN
(AUDIO IN)
FM
AM
FM MONO
TUNING/GROUP
1 sec.
FM/AM/
AUDIO IN
FM FM MONO
AMA_IN
(AUDIO IN)
FM
AM
FM MONO
To select a number, see “How to
select numbers” on page 7.
• You can also use
4 or x.
To select a number, see “How to
select numbers” on page 7.
• You can also use 4 or x.
The PROG. indicator lights up on
the display.
MHz
kHz
DISPLAY/
PROGRAM
1
4
7
0
2
5
8
3
6
9
10
DISPLAY/
PROGRAM
MHz
kHz
FM FM MONO
AMA_IN
FM/AM/
AUDIO IN
(AUDIO IN)
FM
AM
FM MONO
1
4
7
0
2
5
8
3
6
9
10
UX-G200[J].BOOK Page 8 Tuesday, December 2, 2008 3:05 PM