JVC SP-PWC3 Home Theater System User Manual


 
Connections
8
CAUTION
When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
DO NOT connect more than one speaker to one speaker terminal.
Be sure to have them installed on the wall by a qualified
personnel.
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.
Care must be taken in selecting a location for speaker installation
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.
Precautions for daily use
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
When holding a speaker, always grasp the lower portion.
Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
Connecting the satellite
(front, center, surround)
speakers
4
16
FROM
XV-THC3
XV-THS55
XV-THS58
XV-THS66
Connect the black cords to the black (r) terminals.
Connect the white cords to the (q) terminals
referring to the table below:
Speaker cord
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
SP-PWC3
Front speakers
SP-THC3F
Surround speakers
SP-THC3S
Center speaker
SP-THC3C
Do not connect the power cord until all other connections have been made.
TH-C3[B]_new.book Page 8 Thursday, May 19, 2005 1:52 PM