Filter
Top Products
7 Setting the low frequency effect attenuator
—LFE ATT
If the bass sound is distorted while playing back software
encoded with Dolby Digital or DTS, set the LFE level to
eliminate distortion.
• This function takes effect only when the LFE signals come in.
LFE 0dB Normally select this.
LFE –10dB Select when the bass sound is distorted.
Initial setting: 0 dB
Using the Midnight mode—
MIDNIGHT MODE
You can enjoy a powerful sound at night using the Midnight
mode.
When the Midnight mode is activated, the MIDNIGHT
indicator lights up on the display.
MIDNIGHT OFF Select when you want to enjoy surround
with its full dynamic range. (No effect
applied.)
MIDNIGHT 1 Select when you want to reduce the
dynamic range a little.
MIDNIGHT 2 Select when you want to apply the
compression effect fully (useful at night).
Initial setting: OFF
From the remote control:
Press MIDNIGHT repeatedly to select
either one of the above.
Setting the digital input (DIGITAL IN)
terminals—DIGITAL IN 1/2/3
When you use the digital input terminals, register what
components are connected to which terminals—DIGITAL
IN 1/2/3 (see page 14) so that the correct source name will
appear when you select the digital source.
• You cannot adjust directly from the remote control.
Select one of the following components for each terminal:
DVR/DVD For the DVD player (or DVD recorder)
VIDEO For the component connected to the
VIDEO IN jacks on the rear of the receiver
VCR For the VCR
TV For the TV
Initial setting: DVR/DVD (for “DIGITAL IN 1”)
VIDEO (for “DIGITAL IN 2”)
TV (for “DIGITAL IN 3”)
NOTES
• You cannot assign the same component for different terminals.
The priority order for assignment is as follows:
“DIGITAL IN 1” > “DIGITAL IN 2” > “DIGITAL IN 3”
Ex.: When “DIGITAL IN 1” is set to “DVR/DVD.”
DIGITAL IN 1 DVR/DVD VIDEO VCR TV
‘
For “DIGITAL IN 2,” “VIDEO,” “VCR,” and “TV” are selectable.
• In this case, “VCR” is selected.
DIGITAL IN 2 DVR/DVD VIDEO VCR TV
‘
For “DIGITAL IN 3,” “VIDEO” and “TV” are selectable.
DIGITAL IN 3 DVR/DVD VIDEO VCR TV
: Selectable : Not selectable
• Setting “DIGITAL IN 1” affects “DIGITAL IN 2” and “DIGITAL IN 3”
settings. When you have changed “DIGITAL IN 1,” confirm the
components assigned to “DIGITAL IN 2” and “DIGITAL IN 3.”
Setting the Audio delay level—
AUDIO DELAY
Synchronization between audio and video reproduction can
be possibly disturbed because video signal decoding is time-
consuming compared to the audio signal decoding.
On this setting, you can correct synchronization between
video and audio signals by delaying the audio signal timing.
• You cannot adjust directly from the remote control.
Adjustable range: OFF and 10 ms to 150 ms (in 10 ms
intervals)
Initial setting: OFF
NOTE
The audio delay level setting does not take effect when selecting “A
MULTI” for the audio input setting (see page 12).
MIDNIGHT
33
29-34_BasicSt.indd 3329-34_BasicSt.indd 33 06.6.9 2:25:05 PM06.6.9 2:25:05 PM