Filter
Top Products
Page 45
English
Simplifying the Operations Using the Remote Control
You can program and store a series of operations in a specific order you want. After making a program, you
can perform these programed operations at a press of the SEQUENTIAL PROGRAM KEY.
Programing a series of operations
You can make 3 different programs, each containing up to 16 steps.
1 Open the outside panel of the remote control.
2 Press LEARN so that the SEND/LEARN indicator lights up (green).
3 Close the outside panel.
4 Press SEQUENTIAL PROGRAM KEY A, B, or C to which you want to assign a program you
are making from now.
The SEND/LEARN indicator starts flashing.
Note:
If the ERROR indicator lights up (red) while the SEND/LEARN indicator is flashing, you have already
assigned a program to that SEQUENTIAL PROGRAM KEY. To add steps to the program, continue to step
5. If you do not want to change it, press another SEQUENTIAL PROGRAM KEY after the SEND/LEARN
indicator stops flashing.
5 While the SEND/LEARN indicator is flashing, press the button you want to store as the first
step of the program.
Both the SEND/LEARN and ERROR indicators light up, and then only the ERROR indicator goes
off.
When the SEND/LEARN indicator goes off and starts flashing again, the first step is stored.
The ERROR indicator lights up while the SEND/LEARN indicator is flashing.
Note:
If the SEND/LEARN indicator stops flashing before you press the button, repeat from step 4 again.
Remote: Inside
Remote: Outside
CANCELLEARN
SEQUENTIAL PROGRAM KEY
ABC
SEND/LEARN ERROR
Lights
Lights
Lights
SEND/LEARN ERROR
Lights
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
Flashes
Lights
SEND/LEARN ERROR
SEND/LEARN ERROR
Flashes
RX-730RBK(EF)0054-001A.En.42-52 97.7.25, 7:06 PM45