Filter
Top Products
22
Notes:
• EON data sent from some stations may not be compatible with this
receiver.
• In EON standby mode, if you carry out synchronized recording (see
page 31), EON standby mode is canceled temporarily. The receiver
goes back to EON standby mode again when you have finished
that operation.
• The EON mode only works when receiving an FM station with the
EON code. (The EON indicator lights up while receiving an AM
station but the EON function will not work.)
• While listening to a program tuned in by the EON function, you
cannot use source selecting buttons and PTY SEARCH button.
CAUTION:
When the source alternates intermittently between the station tuned in
by the EON function and the currently selected source, press EON to
cancel the EON function.
If you do not press the button, the currently tuned station is received
finally, and the indication of the EON program type flashing on the
display disappears.
When an emergency broadcast (ALARM signal) is sent from an
FM station:
The receiver automatically tunes in the station except in the
following cases:
• When you are listening to non-RDS stations (all AM — MW/LW
and some FM stations).
• When the receiver is in standby mode.
While receiving an emergency broadcast, “ALARM” appears on the
display.
The TEST signal is used for equipment test — whether it can
receive the ALARM signal correctly.
The TEST signal makes the receiver work in the same way as the
ALARM signal does. If the TEST signal is received, the receiver
automatically switches to the station broadcasting the TEST signal.
While receiving the test signal, “TEST” appears on the display.
‘
CASE 1
‘
If there is no station broadcasting the program
you have selected
The receiver continues playing the current source (all sources
except AM — MW/LW).
When a station starts broadcasting the program you have
selected, the receiver automatically switches to the station. The
indicator of received PTY code starts flashing.
When the program is over, the receiver goes back to the
previously selected source, but still remains in EON standby
mode. The indicator of received PTY code stops flashing and
remains lit.
If there is a station broadcasting the program
you have selected
The receiver changes the source (all sources except AM —
MW/LW), and tunes in the station. The indicator of received
PTY code starts flashing.
When the program is over, the receiver goes back to the
previously selected source, but still remains in EON standby
mode. The indicator of received PTY code stops flashing and
remains lit.
CASE 2
‘
CASE 3
‘
If the FM station you are listening to is
broadcasting the program you have selected
The receiver continues to receive the station, but the indicator
of received PTY code starts flashing.
When the program is over, the indicator of received PTY code
stops flashing and remains lit, but the receiver remains in EON
standby mode.
To stop listening to the program selected by EON
Press EON so that the program type (TA/NEWS/INFO) indicator
goes off from the display. The receiver enters EON off mode and
goes back to the previously selected source.
• Each time you press EON, the EON mode alternates between
standby mode and off mode.
EN10_22.RX-7010&7012R[B]_f 01.1.9, 5:23 PM22