Filter
Top Products
32
Setting the Audio delay level
—AUDIO DELAY
Synchronization between audio and video reproduction can be
possibly disturbed because video signal decoding is time-
consuming compared to the audio signal decoding.
On this setting, you can correct synchronization between video
and audio signals by delaying the audio signal timing.
Adjustable range: OFF and 10 ms to 100 ms (in 10 ms intervals)
Initial setting: AUDIO DELAY: OFF
Memorizing the volume level for each
source—ONE TOUCH OP
This receiver memorizes some settings separately for each
source. In addition, you can store the volume level for each source
with the other memorized settings. (See page 22.)
• This receiver memorizes the volume level
– when you turn off the power, and
– when you change the source.
ONE TOUCH OP: ON
Select to store the volume level separately for each
source. (The ONE TOUCH OPERATION indicator lights
up on the display.)
ONE TOUCH OP: OFF
Select this not to store the volume level.
Initial setting: ONE TOUCH OP: OFF
To recall the volume level
With the ONE TOUCH OPERATION indicator lit, the volume level
for the currently selected source is recalled when the source is
selected.
To cancel the One Touch Operation
Set One Touch Operation to “ONE TOUCH OP: OFF” so that the
ONE TOUCH OPERATION indicator goes off from the display.
Selecting the source for HDMI terminal and
COMPONENT VIDEO jacks—HDMI SELECT/
CMPNT SELECT
When you connect a video component other than DVD recorder
or DVD player (VCR or DBS tuner, for example) to the VIDEO
(VCR) IN terminal (jacks) in HDMI terminal or COMPONENT
VIDEO jacks on the rear of the receiver, you need to select either
“VIDEO” or “VCR” according to the component you connect.
If you have not selected appropriate source, you cannot view the
playback picture on the TV.
For the HDMI terminal:
HDMI SELECT: VIDEO
Select this when assigning the HDMI terminal for
a video component (DBS, for example).
HDMI SELECT: VCR
Select this when assigning the HDMI terminal for
a VCR.
Initial setting: HDMI SELECT: VIDEO
For the COMPONENT VIDEO jacks:
CMPNT SELECT: VIDEO
Select this when assigning the COMPONENT
VIDEO jacks for a video component (DBS, for
example).
CMPNT SELECT: VCR
Select this when assigning the COMPONENT
VIDEO jacks for a VCR.
Initial setting: CMPNT SELECT: VIDEO
23-33RX-D701S[B]_f.p65 05.11.7, 2:54 PM32