Filter
Top Products
47
Manufacturer Codes
JVC 00*, 26, 27, 28, 29, 58
Aiwa 01, 02
Bell & Howell 03
Blaupunkt 04, 05
CGM 06, 07
Emerson 08, 10, 11, 12, 64, 65
Fisher 03, 14, 15, 16, 17
Funai 01
GE 18, 19, 20
Goldstar 07
Goodmans 13, 21
Grundig 06, 22
Hitachi 18, 23, 24, 25, 66
Loewe 07, 21
Magnavox 04, 19, 24
Mitsubishi 30, 31, 32, 33, 34, 35
NEC 26, 27
Nokia 03, 36
Nordmende 38
Orion 09
Panasonic 19, 24, 39, 40
Philips 04, 19, 21, 24, 41, 42
Phonola 21
RCA/Proscan 04, 18, 19, 23, 24, 43, 44, 45
SABA 38, 46
Samsung 45, 47, 59, 61, 62, 63
Sanyo 03, 48, 49
Sharp 37, 50
Siemens 03, 51
Sony 52, 53, 54
Telefunken 55, 60
Toshiba 43, 44
Zenith 56, 57
For VCR
To change the transmittable signals for
operating another manufacturer’s VCR
1. Press and hold VCR .
2. Press VCR.
3. Enter manufacturer’s code using buttons 1–9,
and 0.
See the list on the right column to find the code.
4. Release VCR .
The following buttons can be used for operating a VCR:
VCR
: Turn on and off a VCR.
After pressing VCR, you can perform the following operations
on a VCR:
CH +/–: Change the TV channels on a VCR.
1 – 10/0, 0, 100+ (+10):
Select the TV channels.
The 10/0 button will function as the ENTER
button if your VCR requires pressing ENTER
after selecting a channel number.
3: Start playback.
REW: Rewind a tape.
FF: Fast wind a tape.
7: Stop playing or recording.
8: Pause playing. To resume, press 3.
REC PAUSE: Enter recording pause by pressing this button.
To start recording again, press this button
then 3.
5. Try to operate your VCR by pressing VCR .
When your VCR turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
*Initial setting
Manufacturers’ codes are subject to change without notice. If they
are changed, this remote control cannot operate the equipment.
40-50_7032[A]3.pm6 03.5.12, 7:02 PM47