Filter
Top Products
17
English
Recording the External Equipment
When recording from the external equipment, you can select
one of the two recording methods — Manual Recording
and Sound Synchronized Recording.
• Manual Recording — Sound is recorded in stereo (both
on the left and right audio channels). You have to operate
the MD recorder and the external equipment respectively.
• Sound Synchronized Recording — With this method, you
can start recording when the sound signals come into the
MD recorder (sound is recorded in stereo).
Sound Synchronized Recording will stop automatically
if no sound comes in for more than 30 seconds.
If Sound Synchronized Recording will not work
correctly
Use the Manual Recording. Sound Synchronized
Recording starts automatically when the MD recorder
detects sound signals come in. If sound signal is too
weak for this unit to detect, Sound Synchronized
Recording will not start (or will stop even while the
source is being played).
Recording the External Equipment Manually
First of all, make sure the proper cable connections between
XM-G6 MD recorder and external equipment (see also page
6 in this manual, and refer to FS-G6’s Instructions pages
9).
1
Insert a recordable MD.
The MD IN lamp lights orange.
2
Press AUX button to select either analog source or
digital source according to the external equipment.
Each time you press AUX button, AUX mode changes
between “AUX” and “AUX DIGITAL” alternately.
3
Press REC PAUSE button on the MD recorder.
The REC indicator on the MD recorder lights red, and
the MD recorder switches to the recording-pause mode.
4
Press 6 (play/pause) button on the MD recorder
or MD 6 (play/pause) button on the remote
control.
Selected source and remaining time for recording appear
in the display window as follows:
or
5
Make the external equipment start playback in
succession.
• To stop recording temporarily, press REC PAUSE
button or 6 (play/pause) button on the MD recorder
or MD 6 (play/pause) button on the remote control.
• To resume recording, press 6 (play/pause) button
on the MD recorder or MD 6 (play/pause) button
on the remote control again.
Each time you press DISPLAY/CHARA. button,
information switches between the remaining time for
the MD and the elapsed time for the MD alternately.
6
Press 7 (stop) button on the MD recorder to stop
recording as required.
“WRITING” appears in the display window, and you
can remove the MD by pressing 0 (eject) button.
AUX
AUX DIGITAL
Continued
EN11-18.XM-G6[J]/2b 99.12.09, 17:5817