Filter
Top Products
7
ENGLISH
Searching a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Press and hold ¢ or 4 until
“M (manual)” starts flashing on the
display.
3
Tune in to a station you want while “M”
is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for FM
and 9 kHz intervals for AM – MW/LW) until
you release the button.
When an FM stereo broadcast is hard to
receive:
1 Press MODE to enter the functions mode
while listening to an FM stereo broadcast.
2 Press MO (monaural), while still in the
functions mode, so that the MO indicator lights
up on the display.
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved (the ST indicator
goes off).
To restore the stereo effect, repeat steps 1 and
2 so that the MO (monaural) indicator goes off.
FM/AM
DAB
FM1 FM2 FM3 AM
4
¢
4
¢
To tune in to stations of
lower frequencies.
To tune in to stations of
higher frequencies.
MODE
MO
Selected band appears.
EN06_09KSFX772R_FX732R[E]f.pm5 12/14/01, 7:54 PM7