Filter
Top Products
35
ENGLISH
3
Select the character set you want while “ ”
is flashing.
Each time you press the button, the character set changes
as follows:
4
Select a character.
About the available characters, see page 36.
5
Move the cursor to the next (or previous)
character position.
6
Repeat steps 3 to 5 until you finish inputting the name.
7
Press the button while the last selected
character is flashing.
The input name is stored in memory.
To erase the input characters
Insert spaces using the same procedure described above.
Notes:
• When you assign a name to the 41st disc, “NAME FULL” appears on the display. (In this case,
delete unwanted names before assignment.)
• When the CD changer CH-X1200 connected, you can assign names to CDs in CH-X1200. These
names can also be shown on the display if you insert the CDs in this unit.
You can also change the disc title of a CD Text by assigning a name to the disc. However, if you do so,
its performer will not be shown after changing the disc title.
DISP
Capital letters
Small letters
Numbers and symbols
SSM
SEL
EN34-36.KD-SX1000R[J]/1 98.6.3, 4:08 PM35