Filter
Top Products
17
ENGLISH
SOUND ADJUSTMENTS
FAD
BAL
VOL
BAS
TRE
(volume)
LOUD
(loudness)
(bass) (treble) (fader)
(balance)
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the button, the
adjustable items change as
follows:
Indication To do: Range
BAS Adjust the bass. –06 (min.)
|
+06 (max.)
TRE Adjust the treble. –06 (min.)
|
+06 (max.)
FAD* Adjust the front R06 (Rear only)
and rear speaker |
balance. F06 (Front only)
BAL Adjust the left L06 (Left only)
and right speaker |
balance. R06 (Right only)
LOUD Boost low and high
frequencies to LOUD ON
produce a well- |
balanced sound LOUD OFF
at low volume
level.
VOL Adjust the volume. 00 (min.)
|
50 (max.)
* If you are using a two-speaker system, set the fader
level to “00.”
To increase the level.
To decrease the level.
Equalization pattern changes as you adjust
the bass or treble.
2
Adjust the level.
Note:
Normally the control dial works for volume
adjustment. So you do not have to select “VOL” to
adjust the volume level.
Using the sound control
memory
You can select and store a preset sound adjustment
suitable for each playback source.
(Advanced SCM)
Selecting and storing the sound modes
Once you select a sound mode, it is stored in
memory. It will be recalled every time you select
the same source and will be shown on the display.
A sound mode can be stored for each of the
following sources — FM1, FM2, FM3, AM and CD.
• If you do not want to store the sound mode
separately for each playback source, but want to
use the same sound mode for all the sources,
see “To cancel Advanced SCM – SCM LINK” on
page 21.
Select the sound mode you want.
Each time you press the button, the sound mode
changes as follows:
SCM
"Link"
indicator
BEAT
SOFT
POP SCM OFF
EN17-18.KD-S9R[E]f 9/19/00, 9:23 AM17