Filter
Top Products
12
ENGLISH
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM
band (FM1, FM2, and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
Each time you press the button,
the band changes as follows:
2
Start automatic preset.
1 Press M MODE.
“Mode” appears on the display.
The next-step-operation buttons
start flashing.
2 Press and hold number button 5 while
“Mode” is still on the display.
To tune in to stations of
higher frequencies
To tune in to stations of lower frequencies
“–SSM–” appears, then disappears
when automatic preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2, or FM3).
These stations are preset in the number buttons
—No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
Manual preset
You can preset up to 6 stations in each band
(FM1, FM2, FM3, and AM) manually.
Ex.: Storing FM station of 92.5 MHz into the
preset number 1 of the FM1 band.
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the button,
the band changes as follows:
2
Tune in to a station (in this example,
of 92.5 MHz).
FM1 FM2 FM3 AM
FM1 FM2 FM3 AM
EN10-14_KD-LH305[U]f.p65 20/11/03, 12:21 PM12