Filter
Top Products
11
ENGLISH
3
Tune in to a station you want while
“Manual Search” is flashing.
• If you release your finger from the button,
the manual mode automatically turns off
after about 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for
FM and 9 kHz for AM) until you release
the button.
If the sound quality decreases and the
stereo effect is lost while listening to an
FM station
In some areas, adjacent stations may
interfere with each other. If this interference
occurs, this unit can automatically reduce this
interference noise (the initial setting when
shipped from the factory). However, in this
case, the sound quality will be degraded and
the stereo effect will also be lost.
If you do not want to degrade the sound
quality and to lose the stereo effect, rather
than to eliminate the interference noise, see
“To change the FM tuner selectivity—IF Filter”
on page 39.
To tune in to stations of
higher frequencies
To tune in to stations of lower frequencies
When an FM stereo broadcast is hard to
receive:
Set the FM reception mode to “Mono On.”
1 Press M MODE while listening to an FM
stereo broadcast.
“Mode” appears on the display.
The next-step-operation buttons
start flashing.
2 Press number button 1 to select “Mono On”
while “Mode” is still on the display.
Each time you press the button, “Mono On” or
“Mono Off” appears alternately.
The display returns to the source indication
screen.
The sound you hear becomes monaural but the
reception will be improved.
After about
5 seconds
MONO indicator appears.
EN10-14_KD-LH305[U]f.p65 20/11/03, 12:21 PM11