Filter
Top Products
54
ENGLISH
TROUBLESHOOTING
What appears to be trouble is not always serious. Check the following points before calling a service
center.
Remedies
Adjust it to the optimum level.
Check the cords and
connections.
Press the reset button on the
panel holder after detaching the
control panel. (The clock setting
and preset stations stored in
memory are erased.)
(See page 2.)
Remove the control panel, wipe
the connectors, then attach it
again. (See page 39.)
Wait until the operating
temperature resumes—until
(LOW TEMP.) indicator
goes off.
Store stations manually.
Connect the aerial firmly.
Insert the CD correctly.
• Insert a finalized CD-R/
CD-RW.
• Finalize the CD-R/CD-RW
with the component which
you used for recording.
Unlock the CD. (See page 25.)
While holding CD/CD-CH, press
SEL (select) for more than
2 seconds to eject the CD.
Stop playback while driving on
rough roads.
Change the CD.
Check the cords and
connections.
Insert a CD into the loading slot.
Insert the CD correctly.
Causes
The volume level is set to the
minimum level.
Connections are incorrect.
The built-in microcomputer may
have functioned incorrectly due
to noise, etc.
The control panel is not attach
correctly and firmly.
Temperature in the car
compartment is very low—
(LOW TEMP.) indicator appears.
Signals are too weak.
The aerial is not connected
firmly.
CD is inserted upside down.
CD-R/CD-RW is not finalized.
CD is locked.
The CD player may function
incorrectly.
You are driving on rough roads.
CD is scratched.
Connections are incorrect.
No CD in the loading slot.
CD is inserted incorrectly.
Symptoms
• Sound cannot be heard
from the speakers.
• This unit does not work
at all.
•“Panel Connect Error”
appears on the display.
•“Movie” category
settings in the PSM do
not take effect.
• SSM (Strong-station
Sequential Memory)
automatic preset does
not work.
• Static noise while
listening to the radio.
• CD cannot be played
back.
• CD-R/CD-RW cannot be
played back.
• Tracks on the CD-R/
CD-RW cannot be
skipped.
• CD cannot be ejected.
• CD cannot be recognised
(“No Disc,” “Loading
Error,” or “Eject Error”
flashes on the display.)
• CD sound is sometimes
interrupted.
•“No Disc” flashes on the
display.
CD Playback
General
FM/AM
EN53-57KD-LH1101[E_EX]f.p65 2/26/03, 11:47 AM54