Filter
Top Products
KD-G116/KD-G115
Installation/Connection Manual
GET0252-008A
[UT]
1004DTSMDTJEIN
EN, CT
ENGLISH
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If
your vehicle does not have this system, a voltage inverter is required, which can be purchased
at JVC car audio dealers.
J
Handles
F
Washer (ø5)
G
Lock nut (M5)
H
Mounting bolt (M5 x 20 mm)
I
Rubber cushion
A / B
Hard case/Control panel
D
Trim plate
E
Power cord
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
1
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require
information regarding installation kits, consult your JVC car audio dealer or a company supplying
kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualified
technician.
Do the required electrical connections.
*
1
When you stand the receiver, be
careful not to damage the fuse on
the rear.
Bend the appropriate tabs to hold the
sleeve firmly in place.
Removing the receiver
Before removing the receiver, release the rear section.
When installing the receiver without using the sleeve /
In a Toyota for example, first remove the car radio and install the receiver in its place.
When using the optional stay /
Note : When installing the receiver on the mounting bracket, make sure to use the 8 mm-long screws. If longer
screws are used, they could damage the receiver.
Bracket*
Bracket*
*
Not included for this receiver.
Flat type screws
(M5 x 8 mm)*
Pocket
Flat type screws
(M5 x 8 mm)
*
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the receiver at an angle of less than 30˚.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the carʼs chassis using shorter and thicker cords?
• Receiver becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This receiver does not work at all.
* Have you reset your receiver?
C
Sleeve
Insert the two handles, then pull them as illustrated so
that the receiver can be removed.
KD-G116-008A.indd 1 10/16/04 12:19:58 PM