Filter
Top Products
29
ENGLISH
To turn the key-touch tone on or off
—BEEP SWITCH
You can deactivate the key-touch tone if you do
not want it to beep each time you press a button.
When shipped from the factory, the key-touch
tone is activated.
• BEEP ON: Activates the key-touch tone.
• BEEP OFF: Deactivates the key-touch tone.
To adjust the display contrast level
—CONTRAST
Adjust the display contrast (01 – 10) to make the
display indications clear and legible.
When shipped from the factory, the display
contrast level is set at level 05.
To select the scroll mode—SCROLL MODE
You can select the scroll mode for the disc
information (when the entire text cannot be
shown at a time).
When shipped from the factory, scroll mode is set
to “SCROLL ONCE.”
• SCROLL ONCE: Scrolls only once.
• SCROLL AUTO: Repeats the scroll (5-second
intervals in between).
• SCROLL OFF: Cancels scroll mode.
Note:
Even if the scroll mode is set to “SCROLL OFF,” you
can scroll the display by pressing DISP (display) for
more than 1 second.
To select the subwoofer cutoff frequency
—WOOFER FREQ (Only for KD-AR800/KD-G800)
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer.
When shipped from the factory, the subwoofer
cutoff frequency is set to “FREQ MID.”
• FREQ LOW: Frequencies higher than 50 Hz
are cut off to the subwoofer.
• FREQ MID: Frequencies higher than 80 Hz
are cut off to the subwoofer.
• FREQ HIGH: Frequencies higher than 120 Hz
are cut off to the subwoofer.
To adjust the line input level
—LINE ADJ (Only for KD-AR800)
Adjust the line input level properly when an
external component is connected to the LINE IN
plugs.
When shipped from the factory, the line input
level is set at level 00.
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change the source from the external component
to another source.
EN26-33_KD-AR800_G800[J]f.p65 8/12/03, 11:10 AM29